![]() ![]() Sure enough, the next day after they ate there were only crumbs left. He started by just removing one to see if it would work. Mtn Man decided that the support slats were too close together and that we needed to remove every-other one to help the hay slide down better. The hay wasn’t sliding down as easily against the wood back as it did against the plastic back of the indoor ones. This helped a little, but they were still having trouble. So, using his angle grinding tool, Mtn Man cut out some of the wire to make bigger holes and sanded the cut edges smooth. We found almost full leaves of hay still in it when they were done eating.Īt first it seemed the problem was that their Nubian noses couldn’t fit through the holes far enough to reach the hay. Our indoor goat and sheep hay feeders were working so well we felt the design of the fence one would be just as good.īut we noticed right away that the goats were not able to get all the hay. It is wonderful to have a nice manger for the goats and sheep that will keep their food off the ground and prevent waste. Lastly, we cut the end pieces square with the box so it all looked nice.Īnd that is it! We put a little snack in it to see how it worked for the goats and it worked well. Then we put on the last 1×10, still 7 inches from the wire. Once we got that piece on, we realized a center support would be helpful in really making the feeder strong. It was 7 inches from the wire to the board. Then we put the second 1×10 on, this one vertical instead of slanted. Then we used 1×10 to make the end pieces. Next, we used rough sawn 1×10 to build the box. Then we attached the wire to the inside of entire fence, including over the feeder section. Then we put upright 2x4s every 13 inches to help support the wire since we were unable to get the thicker gauge wire we originally wanted. In the feeder section we put the bottom rail lower than the rest of the fence, at about 24 inches off the ground. We were already planning to replace a section of our horse panel fence with new permanent fence, so we did the manger build-in at the same time as building the fence.įirst, we picked which section of fencing would have the feeder. We could have made the same feeders and just hooked them to the fence, but we saw some ideas online and decided to do a feeder that would be built in to the fence and could accommodate all of our goats, sheep, and their young. ![]() ![]() But we needed something for when they are eating outside in the barnyard. We built some hay racks for inside the barn that would help decrease the waste – you can see those by clicking here. When the goats arrived it became very clear what hay wasters they are. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |